|
FAQs
|
| How to reset
Password? |
Going to McBIOS, use power user password: MNO974315743924 to login.
|
| Where I can
download new driver and Firmware? |
|
| How to extend
RAID Set? |
1. Go to RAID Set Function
2. Choose "Expand RAID Set"
3. Select New HDD
4. Go to Volume Set Function
5. Choose "Modify Volume Set"
6.
Select the new capacity
|
| Can I put this
card in PCI slot? |
Yes, you can use this card in PCI revision 2.3 slot
|
| Is it only a 4
digit numerical password, or could it be alphanumeric and more than 4
characters? |
The password can be up to 15 alphanumeric characters.
|
| I set up a
volume and then physically removed it without deleting entry in mcBios
RAID Manager. I wish to reset controller so it will quit notifying me of
the missing volume. |
The RAID Volume is stored in the SATA Drives, you need to delete the
RAID volume you no longer need
|
|
Is there a listing of what the # of beeps mean when boot up with Areca
card? |
The beep while starts up that is one of the controller POST (power
on self test) function. One beep means controller received one PCI
bus reset signal, so the beep number will depend on how many reset
commands from motherboard bios.
|
| What exactly are
"reading errors"? |
The reading error means controller can't read data from that disk.
It could be a disk firmware problem or a disk hardware problem. If
the reading error happens once after a long duty time, it should be
ok. If the reading error happens several times in a short duty time,
you may need to replace it first or replace this disk until it
reports fail.
|
